The RemTEC-01 electric drive

The RemTEC-01 electric drive is used to operate stop valves, control valves and ball valves with 100-1200 mm diameter and 1,6-10 MPa working pressure. The RemTEC-01 electric drive is applied to outdoor installations in explosion hazardous zones of the B-1г class and indoors in explosion hazardous zones of the B-1a class, in explosion hazardous zones of class II in accordance with GOST R 51330.13, where the hazard can be posed by explosive air-vapour and air-gas mixtures of IIA, IIB categories and T1, T2, T3, T4 types in accordance with GOST R 51330.5 and GOST R 51330.11. The electronic control system PBE-7M1 is supplied together with the RemTEC-01 electric drive of the multiturn and rotating type. Functions: the preset speed and torque parameters are adjusted within the valve travel; opening and closing of check valves port size locally or remote-acting; the electric motor is switched off automatically if the stop valve mechanism reaches his end positions; electronic motor protection from fault, overload, open-phase, motor winding overheat, motor check, motor insulation resistance check; the electric motor is switched off automatically if the preset output pressure is overrun at any intermediate position of the stop valve mechanism; the electronic protection of the motor from a short circuit, overload, phase loss, winding overheating; can be connected to the automatic process control systems through the discrete inputs/outputs of RS-485, Profibus and CAN-bus interfaces; the data transfer rate can be programmed, the electric drive sequence number in the network can be set; the drive is operated and adjusted using the remote control IrDA protocol; the stop valve position is shown on the local indicator of position; information about the breakdowns and the commands is saved in a blackbox, the valves condition is diagnosed.

Обозначение: RemTEC-01

Технические характеристики: The motor electric power 0,55 - 4,0 kW. Maximum torque of the reducer output shaft 10 000 Nm. Maximum shaft speed for the reducer 6 - 40 rpm. Explosion protection marking 1ExdIIBT4X.